Microe 1500S Mercury Manual de usuario descargar pdf (Pagina 7)

Page 5

Proper sensor alignment may require minor adjustments to the sensor position with

respect to the scale. This can be performed easily using the optional SmartPrecision

Alignment Tool as illustrated below.

The red, yellow, or green LED will light depending on sensor alignment. Slowly

move the sensor by allowing it to slide on the mounting surface until the green

LED, is illuminated. Optimal alignment will be displayed as a “Bright Green” LED.

IMPORTANT

: Confirm that the green LED blinks when passing over the index.

If not, readjust the sensor in the Y direction and repeat the above procedure.

When alignment is completed, tighten the sensor mounting screws

(0.37Nm [3.3 inch-lbs.] maximum torque).

Confirm green over the full range of motion by sliding

the scale past the sensor. The “green” LED must

remain on over the entire range. If not aligned over the

entire range of motion, loosen the sensor mounting

screws and repeat step 5.

To align the sensor, move

it in the Y or θ

direc-

tions.

SmartPrecision

Alignment Tool

Improper

Alignment LED

Red

Power/

Calibration

Power/

Calibration

Power/

Calibration

Improved

Alignment LED

Yellow

Proper

Alignment LED

Green

Optimal

Alignment LED

Bright Green

15 pin D

connector

to sensor

15 pin D

connector

to sensor

15 pin D

connector

to sensor

SmartPrecision

Alignment Tool

SSAT1500S

SmartPrecision

Alignment Tool

SSAT1500S

SmartPrecision

Alignment Tool

SSAT1500S

Installation Instructions

Linear Encoders - Using Alignment Tool - Alignment

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Comentarios a estos manuales

Sin comentarios

Microe 1500S Mercury Manual de usuario Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Sensores Microe 1500S Mercury